گاز میلان - قیمت گاز رومیزی - خرید اجاق گاز صفحه ای میلان | فروشگاه مرکزی میلان
The second procedure in the stove maintenance programme is to check the stove for poor seals which causes excess air to be drawn into the lit fire chamber resulting in lack of control of the burning fuel, poor combustion and under certain conditions gas leaks from the stove. This is best carried out at the start or end of each heating season or if at anytime the stove burning becomes more difficult to control.
Simply close all the air intakes of the lit stove, put on a pair of heat protecting gloves and take a cigarette lighter or a gas hob lighter. Slowly move the lit cigarette lighter or gas hob lighter around the stove door where it seals against the doorframe. Best to ensure that there are no major drafts in the room at the time of doing this. If the lighter flame is drawn towards the door seals at any point you immediately know that excess air is being drawn into the combustion chamber at this point. Note the whereabouts of any leaks on the sketch and carry on around the glass where it meets the door to ensure there are no leaks between the glass and the glass rope seal. قیمت گاز رومیزی
The next stage in the stove maintenance programme is to sort out any of the leaks that may have been found as soon as possible. Let the woodburning or multifuel stove go out and do not light again until the leaks have been fixed. Poor sealing here under certain conditions can cause poisonous undetectable gases such as carbon monoxide to enter the leaving quarters if poor combustion is taking place in the stove. This is a special concern if smokeless or fossil fuels are being burnt in a multifuel stove. I like to leave the rest of the stove maintenance to the end of the heating season for reasons that will be explained later.
Once the fire in the woodburning or multifuel stove is out and the stove has cooled down, any leaks in the interconnected stove plates can be quickly sorted. In the past I have heard of people breaking their stove apart, re-fire cementing the plate joints and rebuilding the stove. I personally feel this is too much hard work and the same results can be achieved using a much more simplified method. The lid or top plate on most cast iron wood burning or multifuel stoves have a lip, which overhangs the stove body. Check your diagram from earlier to see if you have detected any leaks in this area.
Comments
Post a Comment